Thanks for that. Found this link which may be of some use:
http://forum.multiecuscan.net/viewto...ee3da2b57a702d
I have no idea of how an ELM327 is meant to be wired, but in the absence of any other options, I'll open mine up and see if the instructions on the above thread apply.
Cheers,
Volker
Quote:
Originally Posted by AUFanboy
I had the same problem with an ELM327 v1.4 module that I bought a couple years ago - just gave NO DATA. There were a couple of wires switched around but I can't remember which ones - I accidently fried it while testing it after re-wiring (applied 12v to the OUTPUT side of the 5v voltage regulator on the board -- whoops). Bought a v1.5 and it worked fine out of the box... I also have a bluetooth one that works fine. Seems there are a few bad ones out there.
|